Multi-function

Lets loads of beautiful sunlight in, while it acts as a privacy protection film during the day.

Heat insulation, reduce energy consumption.

Reduce UV rays and protect your beautiful skin. Block off annoying glare, reduce the degree of loss of furniture.

Easy to install

Don't need many steps or tools , only with some water and a squeegee or a towel. Best to work together with two people, will greatly save the time.You could easily put this beautiful window film cover up on the window in several minutes.

Large scope of application

Suitable for any smooth and flat glass surface. Such as: sliding door, bedroom etc.

Different effects during day and night

During the day, the outside glass will have a mirror effect while protecting your privacy. When the indoor light is strong at night, the outside glass will lose the mirror effect, and people outside can see inside.

The one-way perspective effect during the day is that when the outdoor light is stronger than the indoor light, people outside cannot see the indoor situation, and when the indoor light is stronger at night, people outside can see the inside.

Enjoy Great Privacy and Sunshine

The mirror window tint film enables you to enjoy sunlight without compromising your indoor privacy during the daytime. It also improves the appearance of your windows by adding a designer look to the exterior of the whole building.

Make Your Personal Space More Cool

Our DIY self-adhesive window film with excellent heat insulation effect can efficiently block harmful UV rays and meanwhile keep the room temperature down. Save cost and energy while providing you a better space.

Add Security to Your Home

These one-way glass films also can help you to reduce the splash of broken glass, minimize property damage by absorbing impact from break-in attempts and holding shattered glass together.

Installation :

1. Measure the window, and cut the film according to the data. Leave an extra 2cm on each side for easier adjustment.

2. Clean the surface of the window to ensure that there are no stains and dust. Spray a lot of water on the window.

3. Remove the protective film by sign, then spray enough water on the solar film you just separated.

4. Paste the wet side of the film on the glass, and use a hard card like a bank card to squeegee out all bubbles and water.

5. Cut off excess film at the edge to make the window film perfectly fit the window.

6. Use a towel to dry the surface water and keep the window clean.

Notes :

1. Make sure to tear off the protective film before pasting.

2. Spraying enough water (soap water will be better) is the key point. Water makes it easier to smooth out the bubbles.

3. Leave 1- 2cm at the edge to avoid falling or curling.